3D Prints

This is a selection of things I've designed from scratch for 3D printing, that might be useful to other people.

40mm diameter wall mount for holding stairgates in place.

Set of inserts that hold all Codenames and Codenames Duet pieces, and fit inside a single box.

Attachment for Makita impact drivers and drills that has slots for six ¼-inch hex bits. Each bit has a slot below for a 6x3mm magnet.

Little holder for storing a pair of 1-2-3 blocks, and some wingnuts and threaded rods I commonly use with them.

Attachment for Makita impact drivers and drills that can be filled with 6x3mm magnets. This keeps bits and screws held securely even during use.

Simple hook that can be affixed to the inside of a cabinet door to hold a roll of bin bags.

Holder for the porta-filter, spare filter, and scoop/tamper for a Breville coffee machine.

Simple holder to keep the deck or discard piles organised in a game of Terraforming Mars. Has one open side to allow easy access for drawing cards.

Divider that slots across my Terraforming Mars card holder, allowing you to split it into separate sections and store cards vertically.

A shelf designed to sit in the corner of a shelf in a cupboard, and give extra storage room above.

A case for the electronic components of my filament weight sensor.

Holder for a Kindle Paperwhite that fits around a standard UK light switch.

I am releasing these models under the CC BY-NC-SA 4.0 licence. If you wish to make commercial use of them, please get in touch.